Automation · Suction-cup handling
Vacuum Pump for Pick and Place Machine
Pick and Place Machine duty, sized right: fast suction-cup pick and rapid vacuum-break release. Real Yash models, oil-free where it matters, ISO 9001:2015 and built in Faridabad since 1998.
- Duty
- fast suction-cup pick and rapid vacuum-break release
- Airflow
- 10–140 m³/hr
- Vacuum
- −400 to −700 mbar
DTYVacuum for pick-and-place cups
A pick-and-place head lives or dies on vacuum response. Each cycle grabs a part on suction cups, moves it, then releases — often many times a second — so the pump has to build vacuum quickly, hold it firmly through the move, and let the head break vacuum cleanly for a crisp release. The flow per cup is small but the switching is relentless, which rewards a machine that recovers fast and runs cool on continuous duty. Oil-free is essential in electronics and packaging where an oil film would ruin boards or product. A dry vacuum pump is the standard; where the head also needs a pressure blow-off to eject parts, a combined vacuum-and-pressure pump supplies both.
Yash YBDVP dry pumps and YBVP vacuum-and-pressure pumps give automation builders an oil-free, fast-recovering source with nothing to contaminate parts. Quiet enough for the assembly floor, ISO 9001:2015, made in Faridabad and sized on cup count and cycle rate. Quoted in 24 hours.
SZESizing note
Size on total cup area × cycles-per-minute with margin for leaks at the cups, and add a small vacuum reservoir so each pick draws from stored vacuum for instant grip. Fast vacuum-break valving matters as much as pump size for clean release.
Indicative only — final selection depends on your exact duty point, altitude and air temperature. Send the numbers and an engineer confirms the model.
MDLRecommended models
Real Yash models whose published specifications sit inside this machine's duty window. Every figure is from our catalogue — click any model number for its full datasheet.
Dry Vacuum Pump (Only Vacuum)
Full range →Oil-free, fast-recovering vacuum for suction-cup pick — clean grip and cool continuous running with nothing to foul parts.
Dry Vacuum Pump (Vacuum & Pressure)
Full range →Vacuum to pick and a pressure puff to eject — one oil-free unit for heads that need blow-off release.
FAQVacuum Pump for Pick and Place Machine — FAQs
- What vacuum pump is best for a pick and place machine?
- A dry oil-free pump (YBDVP) sized on cup area and cycle rate, buffered by a small vacuum reservoir so each pick grabs from stored vacuum for instant response. If the head ejects parts with a pressure puff, a combined YBVP vacuum-and-pressure pump gives grip and blow-off from one unit.
- How do I get faster, cleaner release on a suction head?
- Pair a fast-recovering pump with quick vacuum-break valving at the head so the cup lets go crisply, and keep a reservoir close to the tooling. Oil-free running is important in electronics and packaging so no oil film transfers to the part on pick.
REFExplore further
RFQ / Request for Quotation
Sizing a vacuum pump for your Pick and Place Machine?
Send your duty point (10–140 m³/hr at −400 to −700 mbar), the machine make and your site voltage — an engineer sizes the exact model and quotes within 24 hours.